Inconel 617 Scrap/ Inconel 617 Foundry Scrap/ Inco 617 Scrap

Product Description

Material Designations

UNS N06617

W.Nr. 2.4663a

EN NiCr23Co12Mo

AFNOR NC22K12D9A

Chemical Composition Range

Nickel (Ni): 44.50 min (Balance ~52.00 - 55.00)

Chromium (Cr): 20.00 - 24.00

Cobalt (Co): 10.00 - 15.00

Molybdenum (Mo): 8.00 - 10.00

Aluminum (Al): 0.80 - 1.50

Carbon (C): 0.05 - 0.15

Iron (Fe): 3.00 max

Manganese (Mn): 1.00 max

Silicon (Si): 1.00 max

Titanium (Ti): 0.60 max

Copper (Cu): 0.50 max

Boron (B): 0.006 max

Sulfur (S): 0.015 max

Phosphorus (P): 0.015 max

Physical Properties

Density: 8.36 g/cm³ (0.302 lb/in³)

Melting Range: 1332°C - 1380°C (2430°F - 2510°F)

Specific Heat (26°C): 419 J/kg·K (0.100 Btu/lb·°F)

Electrical Resistivity (26°C): 1.22 µΩ·m (736 ohm·circ mil/ft)

Mechanical Properties (Typical, Solution Annealed)

Tensile Strength: 760 - 900 MPa (110 - 130 ksi)

Yield Strength (0.2% Offset): 310 - 450 MPa (45 - 65 ksi)

Elongation: 35% - 50%

Hardness: 80 - 95 HRB

Scrap and Foundry Classification

Primary Alloy Category: High Nickel-Chromium-Cobalt Superalloy Scrap

Scrap Forms: Solids, Turnings, Millings, Offcuts, Castings, Foundry Remelt Ingot/Billet

Key Impurity Limits for Foundry Remelt: Silicon <= 0.50%, Iron <= 1.50%, Sulfur <= 0.005%, Oil/Grease < 0.10%

Applicable Specifications

ASTM B166 (Rod, Bar, Wire)

ASTM B168 (Plate, Sheet, Strip)

ASTM B167 (Seamless Pipe and Tube)

ASTM B564 (Forgings)

SAE AMS 5887 (Bars, Forgings)

SAE AMS 5888 (Plate)

SAE AMS 5889 (Sheet, Strip)

AWS A5.14 ERNiCrCoMo-1 (Bare Wire)

AWS A5.11 ENiCrCoMo-1 (Covered Electrodes)